Tools Used To Lay Laminate Flooring

The supplies and materials which are needed to install laminate flooring are affordable.

Tools used to lay laminate flooring.

There are a couple tools you ll need to make sure your laminate boards fit seamlessly together. Save the trimmed sections because you can use these pieces to start other rows. A pull bar to pull floor boards tight a tapping block to prevent edge marring and a pvc spacer set. Problem boards can then be nailed into place.

This is my tool of choice for. Reversed jigsaw blade with teeth pointing down. You will want to have plenty of bits on hand because the laminate flooring is a dense and hard material and will usually eat these bits up pretty quickly. Fcho floor gap fixer tool for laminate floor gap repair include suction cup and mallet can t use on scraped surface floor.

Ez shear marksman laminate flooring cutter for laminate vinyl rubber. This will show you how high up you need to cut the moulding. Table miter circular hand jigsaw dividers chalk line laminate floor cleaner white vinegar pocket plane source. Bullet tools 13 in.

To cut the flooring lay the board on its face bottom up and cut with a saw equipped with a fine tooth blade for flooring. A pull bar rubber mallet a tapping block and a set of spacers. The easiest thing is to buy a kit that includes all of these together. Use an old 5 gallon bucket and cut the laminate flooring right over it allowing the saw dust to fall into the bucket.

Trace a guideline along the surface of the moulding with a pencil. Tapping block pull bar spacers safety goggles gloves utility knife hammer pencil tape measure carpenter s square router drill saws. If needed take a plank of flooring and a section of the underlayment and lay it finished side down next to the door s moulding. This floor installation kit contains the essential tools for installing wood and laminate flooring.

The dremel trio tool is a very cool addition to have when installing laminate flooring because it acts like a plunge router and can make quick work of circular square or rectangle or cutouts in some of your floor pieces. Here are some of the tools you ll need. Use a jamb saw to make this cut. The solid pull bar slips between the wall and board allowing you to tap the board tongue into groove.