Tools To Remove Carpet From Stairs

Steps for removing carpeting from stairs.

Tools to remove carpet from stairs.

Cut the carpet into manageable sections. Use that and rip from there. Our were on the treads and the risers. If not start at the bottom and use your nail puller to loosen a piece and pull from there to rip the carpet up.

Roll it tape it and remove it from the work site. These are the tools you ll need. Cut the carpet with a utility knife under the nose of the landing. Use a crow bar to remove the tack strips.

With gloved hands and using a screwdriver 5 in 1 tool or similar implement pry up a corner until you can gain a grip. Use the vise grips to pull the carpet free from the riser. Work from side to side. Required tools for this how to remove carpet project dust mask knee pads locking pliers pry bar safety glasses utility knife.

Be careful as you rip and pull as there ll be staples or nails in the carpet. Tear out the padding. Removing the carpet tacks and staples. The carpet will be stapled extensively and old staples seem designed to poke fingers or palms so proceed carefully during this step and throughout the removal process.

If both the treads and the risers are carpeted you may be able to slide the blade of a utility knife along an edge without scratching the wood. Start at the top of the stairs and remove the carpet with the vise grips and utility knife. Throw them away as you remove them to avoid accidentally stepping. The hardest part about removing carpet from stairs is starting.

Use a hammer to pull out stray tack strip nails or hammer in any nails that aren t flush. Knee kick to help remove carpeting from the treads locking pliers to remove carpeting from the risers utility knife to cut carpeting into manageable pieces pry bar and hammer to pry tack strips away from the treads 3 inch putty knife to place under the pry bar when.