Tool To Remove Carpet Tack Strips

Remove worn carpet pad and tack strips.

Tool to remove carpet tack strips.

This equals 48 to 72 per hour because it usually takes 3 hours to remove carpet from a 12 by 12 foot room including extracting the tack strips and staples. Cut carpet into haul able pieces. Press the pry bar in order to begin lifting the tack strip. Marshalltown 4 in x 11 in traditional carpet seaming iron.

Then grab the carpet by hand and continue to pull it up along an entire wall. The problem you face is the tack strips that were used to install the carpeting. You ve pulled the carpet up in your living room and you re delighted to find the original hardwood floor beneath. This will create a small space between the carpet tack strip and the floor.

Removing old carpeting may be necessary to save labor costs if you are having your carpet replaced. The floor itself is in great condition. Find carpet tools accessories at lowe s today. Blue hawk 1 in blue tack strip.

Continue pulling up carpet a few feet at a time and cutting it into easy to handle strips. To detach the carpet from the tack strip that holds the carpet in place along walls start in a corner. Once the carpet is removed locate the nails which attach the tack strips to the floor. For pricing and availability.

Safety glasses will protect your eyes in case a piece of the tack strip breaks and becomes airborne. Keep both hands on the knife to avoid cutting a free hand. Roll or fold the strip secure with duct tape and remove it from the room. Detach carpet from tack strip and adjacent surfaces.

At those points slide a pry bar under the tack strip. Gently tap the painter s tool with the hammer until it is underneath the carpet tack strip. Remove all debris from home and dispose of legally. Use the 6 in 1 painter s tool and a hammer to lift one end of one of the strips.

Fold the carpet over for easy cutting and slice it into narrow strips. Carpet removal costs 1 to 1 50 per square foot including labor cleanup and waste disposal. Then tap it with a hammer until the tack strip pops up. Wear gloves to protect your hands from becoming injured on the sharp tacks.

Just grab the carpet with pliers and pull. Includes planning equipment and material acquisition area preparation and protection setup and cleanup. Use a utility knife with a sharp new blade to cut through the carpet backing. The average hourly rate is 60 per hour so expect to pay 180 in total for a contractor to remove and dispose of 12 by.