Support see jane dri.
Toilet water shut off valve leaking uk.
Note that this will shut off the water supply to every appliance in the household including the kitchen tap.
Turn back the water supply and check if there are any leaks on the toilet shut off poppet.
There s an easy way to fix it and you may want to give it a try.
To fix a leaking flapper valve turn the water shut off valve on the intake pipe just below the toilet tank to the closed position.
Close the gate valve on the supply pipe from the cold tank.
Then flush the toilet to empty the tank.
Tightening the water supply line of the shut off valve.
Tighten the packing nut on the toilet shutoff valve one eighth turn clockwise to try to seal a leak around the nut.
The rapid banging or jack hammering sound in a pipe during the fill process during.
If there is a leak shut off the water empty the lines and unscrew the valve s compression nut.
When you re ready to get started shut off the water.
Do not remove the valve just tighten the packing nut.
Next shut off the main water supply to the toilet and detach and drain the pipes using a wrench or pliers.
You can do this by turning the valve by the toilet base clockwise.
The small plastic tub will catch the water from the pipes to avoid spillage.
Hopefully this is enough to compress the rubber gasket so that it is sealed on the valve stem to prevent water leaks.
This will stop the supply of water to the toilet cistern immediately notwithstanding any water that remains in the pipework.
Place the small container underneath the valve in case some water leaks into it while you do the repairs.
Wrap the slip joint pliers jaws in masking tape to protect your shut off valve from any scratches caused by the sharp edges.
If the toilet water shut off valve is not working sometimes the problem lies on the inlet coming from the toilet line of the shut off poppet.
The chain hook must be removed and a new flapper set into its place.
If none you have done it right.
It is located inside the toilet tank at the bottom.
Tighten the packing nut.
Flush the toilet and then remove the flapper valve.
Water hammer can be caused by worn or damaged faucet washers as well as heavy build up of minerals and rust inside shut off valves located on the walls of your home.
Use light steady pressure so you don t damage the water lines.
Water will stop flowing into the tank.
Water leak shut off valve fixing for a leaky toilet water shut off valve the easiest solution is to tighten the package nut 1 4 turn with a wrench.
Cisterns fed from the cold water storage cistern.
Wrap cloth or masking tape on the plier s jaws to protect the nut s finish.
As the water begins filling the toilet s tank check for leaks around the new valve.
