Do not cover the entire float with grout.
Tiling a wall from top to bottom.
When you install ceramic tile on the floor you must take care to create an expansion joint between the walls and the tiled floor.
The tile council of north america recommends at least a quarter inch gap between the tile floor and the walls.
There is chances of slipping of tiles from top to lower.
A batten board is nothing more than a 1 x4 or 1 x2 board screwed directly into the wall horizontally.
On standard three by five shower the back wall we always start center and bottom to top so we have equal cuts in the corner then side walls we start front to back bottom to top so you also have equal cut in corner the combined corner cuts are usally just over a full tile looks great.
In this case draw a vertical line dead centre of the wall and work in both directions from there.
Scoop out a golf ball sized amount of adhesive onto a notched trowel and spread enough adhesive in a thin layer over the wall to hang 2 3 tiles at a time.
Step 1 use a gauge rod to work out the position of the lowest horizontal row then mark the top row s position on the wall.
A batten board helps you start your bottom most course or row of tiles.
Theoretically tiles to be laid from top to bottom but practically it becomes impossible due to above reason.
I have used this method it worked for me.
Start applying the adhesive in a bottom corner about 1 tile length away from the bottom and side of the wall leaving space for the edge tiles.
Begin by scooping up a load of grout onto the grout float using one end of the float.
If you are using ppc cement mortar then do not do it because ppc cement mortar takes much more time to set and chances of slipping of tiles becomes more.
Instead bring it up to about 3 4 of the height of your tiles.
Sweep diagonally across the tile forcing the grout into the joints.
Im not a tiler.
Don t start it at the floor.
If you re only part tiling a wall a top horizontal row full of whole tiles makes for a much cleaner finish so we think it s really worth investing some time to get it right.
Next apply the grout to the tile working from the bottom of the section upwards and holding the float at an angle of about 45 degrees.