Install the hinge pin bushings 1 into the hinges.
Tightening door hinges on 2000 suburban.
Install the washer supplied in the kit and a standard 5 16 inch x 18 nut onto the replacement hinge pin.
Remove the door spring behind the hinge between the hinge and the door itself by locating the end of the spring and inserting the screwdriver between it and the hinge.
Tap the shorter hinge pin 3 into the hinge as far as it will go.
Classic industries offers chevrolet truck door hinges chevrolet truck door lock key chevrolet truck exterior door handles chevrolet truck latches chevrolet truck regulators and parts chevrolet truck rollers chevrolet truck window channels and chevrolet truck.
Find auto door hinge parts for gmc.
Door hinge repair kit fixes the problem of sagging or catching doors by replacing the worn old stock pins and bushings.
Diy if the door still sags after replacing the pins and bushings here s what you can do.
Front side door hinge pin and bushing replacement removal procedure.
Remove the hinge pins from the hinge by grinding the bottom end of the pin off and driving out the remainder of the pin using a hammer and punch.
I can t remember exactly how the obs doors are held on but if it has bolts for the hinges.
Keep doing that process until it lines up.
Buy now at am autoparts.
Classic industries offers a wide selection of body components for your chevrolet truck.
Loosen the bolts that attach the hinge to the body just enough to be able to move the door around a lil.
Est and your order ships same day.
Pry using the door as leverage until the spring pops out.
If it need to go up a lil have a friend lift up on the door a bit then tighten the bolts.
Spray penetrating oil on the top and bottom of the pins at the bushings to make it easier to hammer the pin out.
If the mark is too low raise the latch by tightening the hinges at the top of the door.
Remove the old bushings from the hinges.
Order by 4 p m.
Install the hinge pin bushings 1 into the door side hinges.
Chevrolet truck parts door hinges.
If the lipstick mark is too high tighten the hinges at the bottom of the door with a screwdriver.
When this happens the top corner of the door catches on the door frame and prevents the door from closing properly.
Test fit it don t slam it it might be too far off and could damage something.
Install the shorter hinge pin 3 into the bottom hole in the body side hinge.
If the top corner of your door is catching on the frame you ll need to adjust the hinges 1 x research source another step 2 tighten the screws on the door hinges with a screwdriver.
Step 1 examine the top corner of your door to see if it s catching on the frame.
